Winter weather
Safety Alert!If your area is actively experiencing dangerous weather conditions, wait until it is safe to begin troubleshooting.
While our equipment is designed to withstand harsh winters, downtime is possible if the weather is unusually severe or lasts for an extended period. In the event that you do experience issues with your camera and/or solar equipment, we’ve put together the following troubleshooting tips to help get your system back up and running as quickly as possible.
These tips are regularly updated for the latest TrueLook equipment. If the information below doesn’t look right for your equipment, contact us for recommendations customized to your setup.
Topic
Troubleshooting
Extreme Cold Temperatures
Most of our cameras are built to withstand temperatures as low as -40° F. Weather conditions dipping below this can cause a camera to go offline temporarily, but it should resume normal operation once the temperature goes back up. It’s also important to note that batteries may experience less efficiency in colder conditions.
Limited Sunlight
Extended cloud cover can cause a low voltage disconnect. If this occurs, the system will need full sunshine to recharge and come back online. Depending on how low the charge is, this may take a day or so after the sunlight returns.
Your camera may also go on and offline during this time as it waits to regain sufficient charge levels. You can prevent this by temporarily disconnecting the load to the camera, allowing the battery to charge, and waiting until the voltage has increased before reconnecting it.
We recommend checking that all readouts are within the normal range prior to contacting TrueLook support.
Adjusting Solar Panel Angles
Double-check that your solar panels are facing due south and set to the correct angle for your location. The sun is at a lower angle in the winter months, so non-ideal placement can further decrease efficiency during this time of year. The installation manual for your solar power system has information that on ideal angles for your location. You can also access solar panel data for all U.S. cities, including optimal seasonal angles, through Solarific.
You’ll also want to double-check that nothing is blocking the sun from your solar panels. Trees, buildings, and other objects that aren’t an issue most of the year could be blocking the sun at its lower winter angle.
Removing Snow from Solar Panels
Solar panels typically heat up enough on their own to melt snow and ice quickly. The panels are also designed to withstand the weight of snow and ice that can accumulate.
If you are experiencing extended snowstorms and wish to be proactive, a soft brush can help remove the snow faster. Make sure to do this gently, as a rough brush or too much pressure can damage your solar panels. Also, never use harsh chemicals or abrasive materials on the solar panels.
If your solar panels are closer to ground level (such as on a solar skid or mobile trailer), removing the nearby snow from the ground can help prevent the wind from blowing snow back onto your panels.
Backup Batteries & Voltage
It’s a good idea to routinely check the voltage of your solar power backup batteries so you can spot potential problems before they occur. Battery voltage can be measured at the battery terminals directly with a multimeter or can be viewed from the charge control readings.
Cable Troubleshooting
First, ensure that the cables are connected and do not have any visible damage.
The cables connecting the solar panels to the battery have weather-tight connectors which can be removed for further troubleshooting. If the cable has been in use for a while or was pulled back too hard, the inner copper leads may not be making contact with the opposite lead. Contact support for guidance on how to proceed.
Alternate Power Sources or Batteries
If your area experiences extended cloud coverage and voltage routinely drops below 11.5 Volts DC, you may want to temporarily switch to 110V power for your camera.
If your equipment does not have this built in, there is a 110V adapter that can be added to legacy solar models. Our support team can help you assess if this option is right for your jobsite.
All Other Winter Weather Troubleshooting
Please ensure that all equipment and cabling has been fully inspected before submitting a support request. If all readouts are correct, a few pictures will help TrueLook support diagnose the issue faster. Please share pictures of your equipment setup as well as the inside of any control boxes, especially showing any components that have lights on (or look like they should have lights on).