Prepare for troubleshooting
Point of Contact
It’s important to have a dedicated point of contact for your jobsite. Select someone who is onsite and has direct access to the camera and its components.
Make sure to:
- Provide your point of contact with contact information for TrueLook Customer Support.
- Email pictures of the entire installation to TrueLook Customer Support. Be sure to note any damage or other concerning issues.
Preparation & Tools
See below how to prepare based on your camera’s power type. Have the listed tools ready, but do not attempt troubleshooting without the guidance of Customer Support.
Solar
To Do:
- Email a picture of the charge controller screen (see illustration on right) to TrueLook Customer Support. You can use the left and right arrows to navigate to this screen.
- If the screen is not on, check the battery breaker is in the on position and check for battery voltage. A battery with a low charge will not power the charge controller.
Tool(s) NeededTask
- Multimeter
- Checking power at connections
Phillips head screwdriver
Allen wrenches of various sizes
Opening camera and/or control box enclosure
- Size 1 Phillips head screwdriver
- Troubleshooting modem lights and SIM card
- Small flathead screwdriver
- Wiring terminals located in battery box
- Channel locks or pliers
- Reseating weather-tight cables
110V
To Do:
- If you have a control box, email pictures of the inside of the control box to TrueLook Customer Support.
- If you have an external power converter, email pictures of the inside of the external power converter to TrueLook Customer Support.
Tool(s) NeededTask
MultimeterVerifying power
Phillips head screwdriver
Allen wrenches of various sizes
Opening camera and/or control box enclosure
- Size 1 Phillips head screwdriver
- Troubleshooting modem lights and SIM card
PoE
To Do:
- Email a picture of the PoE lights or the lights on your local powered switch port that the camera is plugged into to TrueLook Customer Support.
- If applicable, email a picture of the camera’s external power indicator light to TrueLook Customer Support.
- Verify that ports 80 and 3128 are open on your local network for the port that the camera is plugged into.