Skyscraper mode

Skyscraper mode is a way to capture taller, high-rise buildings. Follow the steps below to properly turn and activate your camera.

Skyscraper mode is only available for 4K IR Fixed cameras.

Step 1: Rotate your camera lens

Loosen the screw in the camera neck. This will allow you to swivel the camera in any direction.

Rotate the camera lens 90 degrees so that the two sensors are stacked vertically above one another.

Retighten the screw on the camera’s neck. This will lock the camera’s position into place.

Optional: The sunshield on the camera can be moved to the new top of the camera. This is not required, but recommended.

Pull on the tab facing the base of the camera to remove the shield. Slide the front of the shield into the grooves found along the sides of the camera. It should lock in with a click and can be pressed down to fully secure the shield.

If the shield is loose, it did not lock in properly. Remove the shield and try sliding it in again.

Step 2: Contact TrueLook

Contact TrueLook to change the camera settings to Skyscraper Mode. Our team will adjust the camera to show the footage correctly in your dashboard.

Once our team confirms that skyscraper mode has been enabled, we recommend logging into the TrueLook Platform to check the live view of your camera to ensure that the camera is angled the way you’d like and captures the entire project.

Congratulations! Your camera now gets the perfect views of your highest reaching projects.

Returning your camera to a landscape view is similar to the steps above.